More tank liner material, as well as some other bits that are for a later post.
JtC made the trip north to see what damage I had caused with the tank install.
First task: clad the tank straps with rubber liner.
As is so often the case, reproduction parts don't quite fit and for us the new straps were a smidge too wide for the strap liners.
Angle grinder time...
Voila!
Next: mounting the tank vent/roll-over ball valve.
Bit of scrap gal steel bent into a z-bracket...
Bolted in place, on the brace that the rear shocks bolt to...
Finally: fitting the in-tank fuel pump and sender...
J
No comments:
Post a Comment